General-technologies FF310 Fault Finder for Electrical Wiring Open / Sh Manuel d'utilisateur télécharger pdf (Page 2)

1 - Check out list

The FF310 set consists of:

FF310R FaultFinder receiver.

FF310T FaultFinder transmitter.

CT8002 Circuit tester

CT6100 Fuse socket adapter set

 Factory supplied 9- volt alkaline batteries, type Duracell MN1604

Foam padded polypropylene carrying case.

User’s handbook.

2 - Start Up

Both the FF310R and FF310T are factory supplied with batteries. To install the batteries

follow the steps below:

1. Open battery drawer at back of each unit ( factory supplied batteries

are disconnected).

2. Remove the battery, and connect it observing the polarity of the battery connector,

repeating the operation on both units.

3. Press the On/Off button on the FF310T (FaultFinder Transmitter), green LED will

start ashing. If green LED does not starts ashing, check the battery polarity and

reinstall if necessary. To turn the unit off, press the On/Off button again.

4. Press the On/Off button on the FF310R (FaultFinder Receiver), green LED will

turn on. If the green LED does not turn on, check the battery polarity and reinstall

if necessary. To turn the unit off press the On/Off button again.

3 - Switching On and Off the FF310 set

The FF310T

FaultFinder Transmitter is turned on and off by momentarily pressing the “ON/OFF”

button, and it must be turned off manually after use by pressing the On/Off button. Before

storing the unit check to make sure that all lights are off, failure to do so will result in a

much shorter battery life.

The FF300R

FaultFinder Tracer can be turned on and off manually by momentarily pressing the “On/Off”

button, however after 3 minutes of not being used, it will turn off automatically to conserve

battery power. Turning the unit off manually will prolong battery life.

Low Battery indicator

From time to time the batteries on both units will need to be replaced. When the battery

is below the minimum operating voltage, upon turning the unit on (FF310T and FF310R)

both lights will ash for 1 second and the unit will turn off automatically. In this case replace

the batteries with a new set of 9 Volt alkaline batteries. To install the new batteries, follow

the instructions in the preceding section: 2 – Start Up.

Page 1

Table of contents.

1 Check Out list Page 1

2 Start-up Page 1

3 Switching On and Off The FF300 Page 1

4 Setting the sensitivity level Page 2

5 How to use the probe Page 3

6 Locating Short Circuits Page 3

7 Wire tracing Page 4

8 Locating Current Leaks Page 4

9 Locating Open Circuits Page 5

10 Wire Identication Page 5

11 Hook Up Reference Chart Page 6

12 General Procedures Page 7

13 Special Tracing Procedures Page 8

14 Technical specications Page 11

15 CT8002 Circuit Tester Page 12

16 CT6100 Fuse Socket connectors Page 12

17 Care of the unit Page 13

18 Warranty Page 13

Caution

Very Important: Read this rst

• For use only with DC voltage. Do not connect to circuits exceeding 42 volts DC under

any circumstances.

• DO NOT USE on AC voltage.

• Do not use on any circuit directly or indirectly connected to AC lines or any other AC

power source.

• Do not use with any component or part of the ignition system.

• Before using this device check the vehicle’s electrical wiring and disconnect any part

or subsystem sensitive to voltage and current pulses such as air bags, electronic

control modules, etc.

• Always follow the instructions and procedures indicated in the vehicle’s

service manual before attempting to disconnect any part or subsystem of the

electrical circuit.

Exceeding the limits listed above when using this apparatus, or not observing

the precautions listed above can expose you to physical injury and permanently

damage your instrument and parts and components of the vehicle under test.

“V Ready” and “GTC” are registered trademarks of General Technologies Corp.

1 2 3 4 5 6 7 8 9

Commentaires sur ces manuels

Pas de commentaire

General-technologies FF310 Fault Finder for Electrical Wiring Open / Sh Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques General-technologies FF310 Fault Finder for Electrical Wiring Open / Sh